Yamaha CSP-150 CSP-170/CSP-150 Owners Manual - Page 35
Assembly - csp 150b
View all Yamaha CSP-150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Assembly This illustration shows the CSP-170. CAUTION • Assemble the unit on a hard and flat floor with ample space. • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble the unit in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten all screws upon completing assembly of the unit. • To disassemble the unit, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. Remove all parts from the package and make sure you have all of the items. Remove polystyrene foam pads from the package, position them on the floor, then place A on top of them. Position the pads so that they will not block the speaker box or connector on the bottom of A. A Power cord Cord holders x 2 G 6 x 20 mm x 10 K 4 x 20 mm x 4 Headphone hanger L 4 x 10 mm x 2 CSP-170B / CSP-170PE CSP-150B / CSP-150PE H, J Black 4 x 12 mm x 4 CSP-170WH CSP-150WH H Black 4 x 12 mm x 2 J Silver 4 x 12 mm x 2 1 Attach C to D and E. Untie and straighten out the bundled pedal cord. Do not discard the vinyl tie. You will need it later in step 5. Polystyrene foam pads B C Bundled pedal cord inside D E F E G C D G Insert the protrusions into the holes on the brackets, then attach D and E to C by tightening G (x 4). Assembly CSP-170/CSP-150 Owner's Manual 35