Yamaha CVP-900 Owner's Manual - Page 162
After completing the assembly, please check the following. - review
View all Yamaha CVP-900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Keyboard Stand Assembly 3 Insert the pedal cord plug into the pedal connector. Insert the plug so the arrow side faces front (toward the keyboard). If the plug will not go in easily, do not force it. Double-check the orientation of the plug, then try again. 4 Attach the cord holder on the unit as shown in the illustration below, then use the cord holder to affix the pedal cord. 3 4 4 Raising the unit to the standing position. Use the front legs as support to raise the unit. CAUTION • Be careful not to pinch your fingers. • When you raise the unit, do not hold the key cover. 5 Connect the power cord. 6 Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. ■ After completing the assembly, please check the following. • Are there any parts left over? → Review the assembly procedure and correct any errors. • Is the Clavinova clear of doors and other movable fixtures? → Move the Clavinova to an appropriate location. • Does the Clavinova make a rattling noise when you shake it? → Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? → Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? → Check the connection. • If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. When moving the instrument after assembly, always hold the bottom of the main unit. CAUTION Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Top portion Left of the rear leg on the bottom of the main unit, when viewed from front Key cover 162 CVP-900