Yamaha EMX5016CF Owner's Manual - Page 23

Master Section O P U V Reference Front & Rear Panels O ST SUB OUT Jacks These unbalanced phone jacks output the mixed stereo signal (L and R), where the level is adjusted by the ST Q SUB OUT control g. You would typically use these jacks to connect to an external mixer or a supplemen- T tary SR system. P REC OUT Jacks R These RCA pin-type unbalanced output jacks can be S used to send the main stereo signal to an external DAT recorder or cassette recorder. The jacks output the ste- reo signal pre adjustment by the ST master fader l and graphic equalizer W. As the signal is not adjusted W by these controls, please be sure to make appropriate level adjustments at the external recording device side. Q EFF1/2 ON/OFF Jacks These phone input jacks are for connection to a separately sold FC5 foot switch. The foot switch can be used as an alternative to the ON switch to toggle the effector on and off. R ST OUT Jacks These unbalanced phone jacks output the mixed stereo signal (L and R), where the level is adjusted by the ST master fader l. You would typically connect these jacks to a power amp or powered speakers. S PHONES Jack Connector for headphones. This is a balanced stereo phone-type output jack. T LAMP Jack This XLR 3 pin-type output jack is for connection to an optional lamp. NOTE Supported lamps: 12 V (AC or DC), max. 5 W. Power of 12 V is supplied between pins 2 and 3. Pin 1 is not connected. U GEQ (Graphic Equalizer) display Indicates the GEQ settings. This 9-band GEQ adjusts the frequency characteristics of the stereo-bus signal output at the ST OUT jacks R, ST SUB OUT jacks O, and SPEAKERS jacks m. V GEQ +/- Switches These switches boost or cut the gain of each frequency band by ±12 dB. The central frequencies for the bands are: 63, 125, 250, 500, 1k, 2k, 4k, 8k and 16k Hz. The adjustable gain values are: 0dB, ±1.5dB, ±3dB, ±4.5dB, ±6dB, ±9dB and ±12dB. For intermediate values not printed on the scale, both the upper and lower indicators light. (For example, the 0 and +3 indicators light to indicate a value of +1.5dB.) W GEQ ON Switch This switch toggles the graphic equalizer on or off. The switch is illuminated when on. EMX5016CF Owner's Manual 23