Yamaha HTR-3069 HTR-3069 Owner s Manual - Page 67
The TV does not support HDCP High-bandwidth Digital Content
View all Yamaha HTR-3069 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Problem Cause Remedy The playback source does not contain Low Frequency Effect (LFE) To check it, set "Extra Bass" in the "Setup" menu to "On", in order to output the or low-frequency signals. front channel low-frequency components from the subwoofer (p.51). No sound is coming from the subwoofer. Subwoofer output is disabled. The volume of the subwoofer is too low. Perform YPAO (p.25) or set "Subwoofer" in the "Setup" menu to "Use" (p.50). Adjust the volume on the subwoofer. The subwoofer has been turned off by its auto-standby function. Disable the auto-standby function of the subwoofer or adjust its sensitivity level. The TV does not support HDCP (High-bandwidth Digital Content Protection). Refer to the instruction manuals for the TV and check the TV's specifications. No sound from the playback device (connected to The unit is set not to output audio input through HDMI jacks from the unit with HDMI). the SPEAKERS terminals. In "Audio Output" in the "Setup" menu, set "Amp" to "On" (p.53). The number of devices connected to the HDMI OUT jack exceeds the limit. Disconnect some of the HDMI devices. The TV is set to output audio from the TV speakers. Change the audio output setting on your TV so that the TV audio is output from the speakers connected to the unit. No sound from the TV (when HDMI Control is used). A TV that does not support ARC is connected to the unit only with an HDMI cable. (If the TV is connected to the unit with an audio cable) The TV audio input setting does not match the actual connection. Use a digital optical cable to make an audio connection (p.19). Use "TV Audio Input" in the "Setup" menu to select the correct audio input jack (p.53). (If you are trying to use ARC) ARC is disabled on the unit or TV. Set "ARC" in the "Setup" menu to "On" (p.54). Also, enable ARC on the TV. When playing back DSD audio, the unit disables the audio output from a TV. The unit does not support DSD audio output from a TV. Change the audio output setting on the playback device to PCM. Only the front speakers work on multichannel audio. The playback device is set to output 2-channel audio (such as PCM) only. To check it, use "Signal Info." in the "Option" menu (p.45). If necessary, change the digital audio output setting on the playback device. Noise/hum is heard. The unit is too close to another digital or radio frequency device. The cable connecting the unit and playback device is defective. Move the unit further away from the device. If there is no problem with the connection, replace with another cable. The sound is distorted. The volume of the unit is too high. A device connected to the unit's output jacks is not turned on. Turn down the volume. If "ECO Mode" in the "Setup" menu is set to "On", set it to "Off" (p.57). Turn on all devices connected to the unit's output jacks. 67 En