Yamaha HTR-5920 Owners Manual - Page 15
Connecting speakers, Connecting to the SPEAKERS terminal, Connecting to the SUBWOOFER, OUTPUT jack - turns off
View all Yamaha HTR-5920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PREPARATION Connecting speakers Be sure to connect the left channel (L), right channel (R), "+" (red) and "-" (black) properly. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. CAUTION • Use speakers with the specified impedance shown on the rear panel of this unit. • Before connecting the speakers, make sure that this unit is turned off. • Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/or speakers. • Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the speakers away from the monitor. CONNECTIONS ■ Connecting to the SPEAKERS terminal A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a stripe, groove or ridges. Connect the striped (grooved, etc.) cable to the "+" (red) terminals of this unit and your speaker. Connect the plain cable to the "-" (black) terminals. 1 Remove approximately 10 mm (3/8") of insulation from the end of each speaker cable and then twist the exposed wires of the cable together to prevent short circuits. 10 mm (3/8") 2 Press and open the tab. 2 4 3 Red: positive (+) Black: negative (-) 3 Insert one bare wire into the hole of each terminal. 4 Release the tab to secure the wire. ■ Connecting to the SUBWOOFER OUTPUT jack If you do not use the YAMAHA SW-P170 subwoofer, connect a subwoofer with a built-in amplifier. Connect the input jack of your subwoofer to the SUBWOOFER OUTPUT jack using the subwoofer cable. English 11