Yamaha R-S700BL Owners Manual - Page 9
CD DIRECT AMP and indicator R-S700 only, REC OUT selector - speaker selector
View all Yamaha R-S700BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INTRODUCTION 9 PRESET j / i Selects a preset FM/AM station when TUNER is selected as the input source (see page 24). Selects a preset SIRIUS channel when SIRIUS is selected as the input source (see page 31). 0 FM/CATEGORY l, AM/CATEGORY h Sets the FM/AM tuner band to FM or AM when TUNER is selected as the input source (see page 20). Selects a channel category when SIRIUS is selected as the input source (see page 29). A TUNING/CH jj / ii Selects the tuning frequency when TUNER is selected as the input source (see page 20). Searches for a SIRIUS channel when SIRIUS is selected as the input source (see page 29). B Remote control sensor Receives infrared signals from the remote control. Note Switch the remote control ID between ID1 and ID2 when using multiple Yamaha receivers or amplifiers (see page 44). C ZONE 2 Turns on Zone 2 or sets ZONE 2 to standby mode. When Zone 2 is turned on, signals are output to the ZONE 2 OUT jacks (see page 45). D ZONE 2 CONTROL Allows buttons and controls on the front panel to be used to control Zone 2. For more information about controlling Zone 2, see page 46. E CD DIRECT AMP and indicator (R-S700 only) Allows you to listen to a CD source in the purest possible sound (see page 17). The indicator lights up and the front panel display turns off when this function is turned on. Notes • If both the CD DIRECT AMP and the PURE DIRECT are turned on, only the CD DIRECT AMP will function. • Zone 2 cannot be used while this function is turned on. F PURE DIRECT and indicator Allows you to listen to a source in the purest possible sound (see page 17). The indicator above it lights up and the front panel display turns off when this function is turned on. Note Zone 2 cannot be used while this function is turned on. G PHONES jack Outputs audio to your headphones for private listening. Note Press SPEAKER A/B so that the SP A/B indicators turn off before you connect your headphones to the PHONES jack. CONTROLS AND FUNCTIONS H REC OUT selector Selects a source for recording to a CD recorder or to a tape deck independently of the INPUT selector setting, allowing you to record the selected source while listening to another source (see page 19). I BASS control Increases or decreases the low frequency response. The center position produces a flat response (see page 18). J TREBLE control Increases or decreases the high frequency response. The center position produces a flat response (see page 18). K BALANCE control Adjusts the sound output balance of the left and right speakers to compensate for sound imbalances caused by speaker locations or listening room conditions (see page 18). L LOUDNESS control Retains a full tonal range at any volume level to compensate for the human ears' loss of sensitivity to high and low-frequency ranges at a low volume level (see page 18). M INPUT selector Selects the input source you want to listen to. N VOLUME control ( R-S700 only) Increases or decreases the sound output level. Note This does not affect the output level of the REC jacks. 5 En