Yamaha RX V365 Owner's Manual - Page 34

Using Bluetooth™ components You can connect a Bluetooth Wireless Audio Receiver (such as YBA-10, sold separately) to the DOCK terminal of this unit and enjoy the music contents stored in your Bluetooth component (such as a portable music player) without wiring between this unit and the Bluetooth component. You need to perform "pairing" for the connected Bluetooth receiver and your Bluetooth component in advance. Pairing the Bluetooth™ receiver and your Bluetooth™ component Pairing must be performed when you use a Bluetooth component with the Bluetooth receiver connected to this unit for the first time or if the pairing data has been deleted. "Pairing" refers to the operation of registering a Bluetooth component for Bluetooth communications. y • You need to perform the pairing operation only when you use the Bluetooth component with the Bluetooth receiver for the first time. • You need to perform the pairing operations both on this unit and on the Bluetooth component. If necessary, refer to operating instructions of the Bluetooth component. 5 Select the Bluetooth receiver in the Bluetooth device list and then enter the pass key "0000" to the Bluetooth component. When the pairing is completed successfully, "Completed" appears on the front panel display. Note • The Bluetooth Wireless Audio Receiver can be paired with up to eight other components. When pairing is conducted successfully with a ninth component and the pairing data is registered, the pairing data for the least recently used other component is cleared. Playback of the Bluetooth™ component There are two pairing methods: pairing by using "START PAIRING" in "SET MENU" and quick pairing. ■ Pairing by using "SET MENU" Use this feature to perform pairing of this unit and the video monitor. Select "START PAIRING" in "INPUT MENU." See page 36 for details. ■ Quick pairing To ensure security, a time limit of 8 minutes is set for the pairing operation. You are recommended to read and fully understand all the instructions before starting. 1 Press hAMP and then press NINPUT l / h repeatedly (or press fV-AUX/DOCK) to select "V-AUX" as the input source. 2 Turn on the Bluetooth component you want to pair with. 3 Press and hold GBAND (or jBAND LEVEL TITLE) for 3 seconds. Once the Bluetooth receiver starts pairing, "Searching..." appears for a moment. While the Bluetooth receiver is in the pairing mode, DOCK indicator flashes on the front panel display. y • To cancel the pairing, press GBAND (or jBAND LEVEL TITLE) again. Note • If the Bluetooth receiver is not connected to the DOCK terminal of this unit, "No BT adapter" appears on the front panel display. 4 Check that the Bluetooth component detects the Bluetooth receiver. If the Bluetooth component detects the Bluetooth receiver, "YBA-10 YAMAHA" (example) appears in the Bluetooth device list. 1 Press hAMP and then press NINPUT l / h repeatedly (or press fV-AUX/DOCK) to select "V-AUX" as the input source. 2 Start playback of your Bluetooth component. When the connected Bluetooth receiver detects the Bluetooth component, "BT connected" and the DOCK indicator appears on the front panel display. y • When you press lENTER on the remote control, the connected Bluetooth receiver searches and connect to the last connected Bluetooth component. If the Bluetooth receiver cannot find the Bluetooth component, "Not found" appears on the front panel display. • To disconnect the Bluetooth receiver from the Bluetooth component, press nRETURN. 30 En