Yamaha RX V365 Owner's Manual - Page 43

INTRODUCTION PREPARATION BASIC OPERATION Remote control features Setting remote control codes You can control other components by setting the appropriate remote control codes. For a complete list of available remote control codes, refer to "List of remote control codes" at the end of this manual. Remote control code default settings Input source Component category Manufacturer Default code CD CD Yamaha 5013 MD/CD-R CD-R Yamaha 5001 TUNER TUNER Yamaha 5007 DVD DVD Yamaha 2000 DTV/CBL - - - V-AUX/ DOCK TUNER Yamaha 5011 DVR DVR Yamaha 2011 A TUNER Yamaha 5012 B TUNER Yamaha 5009 C TUNER Yamaha 5017 D - - - E - - - Note • You may not be able to operate your Yamaha component even if a Yamaha remote control code is preset as listed above. In this case, try setting another Yamaha remote control code. 1 While pressing and holding one of the input selector buttons (f) on the remote control to select the input area you want to set up, press bAV POWER for more than 3 seconds. A B C 2 Press the numeric buttons (0 to 9) (y) to enter the four-digit remote control code for the component to be used. When the setting succeeds, "RemoteSetup OK" appears; however, when it dues not, "RemoteSetup NG" appears on the front panel display. Notes • If the manufacturer of your component has more than one code, try each of them until you find the correct one. • If you do not press any buttons within 30 seconds in step 2, the setup process is canceled. If this happens, repeat the setup procedure. ■ Resetting all remote control codes Use this feature to clear all the remote control codes previously set and reset all of them to the initial factory settings. 1 While pressing and holding hAMP, press bAV POWER for more than 3 seconds. AMP POWER AV While holding down Press for 3 seconds 2 Press the numeric buttons (y) to enter the code number "9981." "RemoteSetup OK" appears on the front panel display, and the remote control codes previously set are cleared and reset to the initial factory settings. y • If you do not press any buttons within 30 seconds after step 1, the clearing process is canceled. In this case, repeat the clearing procedure. CD MD/CD-R TUNER DVD DTV/CBL DVR V-AUX/DOCK D E POWER AV Press for 3 seconds While holding down ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 39 En