Yamaha RX-V390RDS Owner's Manual - Page 10
ANTENNA CONNECTIONS, Connecting the AM loop antenna, GND terminal, Notes, FM ANT
View all Yamaha RX-V390RDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ANTENNA CONNECTIONS q Each antenna should be connected to the designated terminals correctly, referring to the following diagram. q Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement. Outdoor FM antenna Indoor FM antenna (included) Outdoor AM antenna 300-ohm feeder 75-ohm coaxial cable 75-ohm/300-ohm antenna adapter FM 75Ω ANT UNBAL. GND AM ANT VIDEO SIGNAL GND LD/TV IN VCR OUT MONITOR OUT -l0 dB 0 dB FRONT LEVEL PHONO TAPE CD LD/TV TAPE PB REC OUT AUDIO SIGNAL AM loop antenna (included) Ground Connecting the AM loop antenna 1 2 3 Orient so that the best reception is obtained. * The AM loop antenna should be placed apart from the main unit. The antenna may be hung on a wall. * The AM loop antenna should be kept connected, even if an outdoor AM antenna is connected to this unit. GND terminal For maximum safety and minimum interference, connect the GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. 10 Notes q When connecting the indoor FM antenna, insert its connector into the FM ANT terminal firmly. q If you need an outdoor FM antenna to improve FM reception quality, either 300-ohm feeder or coaxial cable may be used. In locations troubled by electrical interference, coaxial cable is preferable.