Yamaha RX-V475 RX-V575/RX-V475 Owners Manual - Page 32
To start the measurement, use the cursor keys to, to select SAVE and press ENTER. - subwoofer not working
View all Yamaha RX-V475 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
1 2 3 4 5 6 7 8 9 10 Automatic speaker setup CODE SET SOURCE RECEIVER HDMI 1 2 3 4 MHL 1 2 3 5 AV 4 5 6 A V-AUX AUDIO FM INFO USB NET B ZONE TUNER AM MEMORY PRESET TUNING MOVIE MUSIC SUR. DECODE STRAIGHT SLEEP BD DVD SETUP ENHANCER DIRECT SCENE TV NET RADIO OPTION ENTER VOLUME RETURN DISPLAY TOP MENU MODE POP-UP MUTE MENU 1 2 3 4 5 6 7 8 9 INPUT MUTE 0 10 TV TV VOL TV CH ENT SOURCE/RECEIVER • To cancel the operation, disconnect the YPAO microphone, or use the cursor keys to select "Exit" and press ENTER, before starting the measurement. SETUP Cursor keys ENTER RETURN • Do not stand between the speakers and the YPAO microphone during the measurement process (about 3 minutes). • Move to the corner of the room or leave the room. 5 To start the measurement, use the cursor keys to select "Start" and press SETUP. The measurement will start in 10 seconds. Press ENTER to start the measurement immediately. • To stop the measurement temporarily, press RETURN and follow the procedure in "Error messages" (p.33). • If cursor keys do not work, the remote control may be set to the external device operation mode. In this case, press SOURCE/RECEIVER to set the remote control to the unit operation mode (the key lights up in orange) and then use the cursor keys. The following screen appears on the TV when the measurement finishes. Auto Setup Start Exit Measurement Finished Result 3 / 2 / 0.1 ch 3.0 / 10.5 m -3.0 / +10.0 dB OK:ENTER 1 2 3 4 1 The number of speakers (front side/rear side/subwoofer) 2 Speaker distance (nearest/farthest) 3 Adjustment range of speaker output level 4 Warning message (if available) • A speaker with a problem is indicated by blinking of the speaker indicators in the front display. • If multiple warnings are given (when operating with the front display), use the cursor keys (q/w) to check the other warning messages. 6 To save the measurement results, use the cursor keys (e/r) to select "SAVE" and press ENTER. Auto Setup Start Exit SAVE Measurement Finished Result 3 / 2 / 0.1 ch 3.0 / 10.5 m -3.0 / +10.0 dB The adjusted speaker settings are applied. • To finish the measurement without saving the result, select "CANCEL". 7 Disconnect the YPAO microphone from the unit. This completes optimization of the speaker settings. Caution • The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be exposed to direct sunlight or high temperatures (such as on top of AV equipment). • If any error message (such as E-1) or warning message (such as W-1) appears, see "Error messages" (p.33) or "Warning messages" (p.34). PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO) En 32