Yamaha RX-V595aRDS Owner's Manual - Page 44

REMOTE CONTROL You can use the remote control to control not only this unit but also other components connected to it. The remote control is factory set to control this unit and most YAMAHA audio components. To control other brands of components, you must preset the remote control with the manufacturers' codes listed from page 369. Components which can be controlled There are nine positions that you can select to control connected components with this remote control. When turning the SELECTOR DIAL, the position changes as follows: AMP/TUN: You can perform the basic operations of this unit with the SELECTOR DIAL set to this position. TV: A television can be controlled. CBL/DBS: A cable television or DBS tuner can be controlled. VCR: A VCR can be controlled. SELECTOR DIAL TAPE/MD: The code for a YAMAHA tape deck is preset. (Be sure to preset the proper code when operating a YAMAHA MD recorder.) CD: The code for a YAMAHA CD player is preset. DSP: This unit can be controlled and DSP programs can be selected directly. DVD/LD & DVD MENU: An LD player can be controlled by using the DVD/LD position. A DVD player can be controlled by using the DVD/LD and DVD MENU positions. The code for a YAMAHA DVD player is preset. If the remote control will not operate your YAMAHA DVD player, you need to preset code number "4490." Notes 1. The shaded positions in the diagram above indicate that you can preset the code for the manufacturer of your component. Note that you can preset only one code for one position. (See "SETUP CODES" on page 50 for details). 2. DVD/LD and DVD MENU positions: • Be sure that the SELECTOR DIAL is set to the DVD/LD position before presetting the code for a DVD or an LD player. The code that you preset to the DVD/LD position is also simultaneously preset to the DVD MENU position. You cannot preset the code for a DVD player when the SELECTOR DIAL is set to the DVD MENU position. • DVD MENU operations cannot be performed for some DVD players. 3. When using a second (and third) VCR (See "To use a second (and third) VCR" on page 50 for details.): • If you are not using a CBL/DBS (cable TV or DBS tuner), the second (or third) VCR can be preset by using the CBL/DBS position. • If you are not using a DVD player, the second (or third) VCR can be preset by using the DVD MENU position. Note that in this case you must preset the code for an LD player to the DVD/LD position even if an LD player is not being used. 4. The button functions on the remote control differ depending on the position selected by the SELECTOR DIAL. Refer to the following pages for details. Basic operation 1 Select the position for the component that you want to control by turning the SELECTOR DIAL. Note: Turn the SELECTOR DIAL until it stops with a click. 2 Press the desired operation button. Note: Press the button with the remote control aimed at the front panel. The position name is displayed in this window. Indicator The indicator will flash when the button is pressed. 44