Yamaha RX-V863 Owner's Manual - Page 122
SIRIUS Satellite Radio, Remote control, Status message, Cause, Remedy, Problem - firmware
View all Yamaha RX-V863 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Troubleshooting ■ SIRIUS Satellite Radio If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the cause and follow the corresponding remedies. Status message ANTENNA ERROR CHECK SR TUNER NOT SUPPORTED ACQUIRING UPDATING F/W UPDATING CALL SIRIUS (CALL 888-539SIRIUS TO SUBSCRIBE) SUB UPDATED INVALID Not Available Cause Remedy The antenna is not connected to the SiriusConnect tuner properly. The SiriusConnect tuner is not connected to the SIRIUS jack of this unit correctly. The SiriusConnect tuner is not connected to the AC wall outlet. This unit does not support the connected SIRIUS Satellite Radio tuner. The signal is too weak. The SiriusConnect tuner is updating the channel list. The period of the subscription is end. The SiriusConnect tuner is updating the firmware. The selected channel is not subscribed. The subscription information is updated. The selected channel is currently out of service. The operation you made is not available. Check the connection of the antenna and SiriusConnect tuner. Check the connection of the SiriusConnect tuner and this unit. Connect the power cable of the SiriusConnect tuner to the AC wall outlet. Connect the SiriusConnect tuner that this unit supports, Adjust the orientation of the antenna of the SiriusConnect tuner. Use the "ANTENNA INFO" information in the front panel display or "SIRIUS Information" screen in the video monitor to check the antenna reception level. Wait until the updating is complete. Contact SIRIUS Satellite Radio to renew the subscription. Wait until the updating is complete. Contact SIRIUS Satellite Radio to subscribe the selected channel. URL: https://activate.siriusradio.com/ Phone: 1-888-539-SIRIUS (1-888-539-7474) Select another channel. Select another channel. See page 64 64 64 64 64, 69 - 65 - 65 65 65 ■ Remote control Problem The remote control does not work or function properly. Cause Remedy Wrong distance or angle. The remote control will function within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. Direct sunlight or lighting (from an inverter Reposition this unit. type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. Replace all batteries. The operation mode selector is set incorrectly. Set the operation mode selector correctly. When operating this unit, set it to the FAMP position. When operating the component selected by the input selector button, set it to the FSOURCE position. When operating the TV set in the 4DTV or 4PHONO area, set it to the FTV position. The remote control code was not correctly Set the remote control code correctly using "List of set. remote control codes" at the end of this manual. Try setting another code of the same manufacturer using "List of remote control codes" at the end of this manual. The ID code of the remote control and the Match the remote control ID of this unit with the remote control ID of this unit do not match. corresponding remote control ID code. See page 31 - - - 104 104 110 118 En