Yamaha Tio1608-D2 Tio1608-D2 Owners Manual - Page 12
Switch 4 Dante SECONDARY port mode
View all Yamaha Tio1608-D2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
NOTE If switches 7 and 8 are set to the "update mode" or "diagnostic mode" positions, the unit will not be reset. • Switches 3, 7 and 8 (Tio1608-D compatibility mode) This mode is used to connect to older models that are not compatible with the Tio1608-D2. In the compatibility mode, the sampling frequency is set to the maximum 48 kHz and external devices recognize Tio1608-D2 as Tio1608-D. Switch position Operating mode Tio1608-D compatibility mode 378 Cancels the Tio1608-D compatibility mode 3 7 8 (initialize mode) - Activating the Tio1608-D compatibility mode Configure the dip switches as shown above for "Tio1608-D compatibility mode" and then switch the power ON. When the red indicators on the front panel stop flashing and only the green indicators are flashing, that indicates the compatibility mode has been successfully activated. Then switch the power OFF, reconfigure the dip switch settings appropriately, and switch the power back ON before using the system. The green [SYSTEM] indicators will flash for about 20 seconds only after switching to the Tio1608D compatibility mode. - Canceling the Tio1608-D compatibility mode Configure the dip switches as shown above for "Cancels the Tio1608-D compatibility mode" and then switch the power ON. When the red indicators on the front panel stop flashing and only the green indicators are flashing, that indicates the compatibility mode has been successfully canceled. Then switch the power OFF, reconfigure the dip switch settings appropriately, and switch the power back ON before using the system. • Switch 4 (Dante SECONDARY port mode) This switch determines the operating mode of the Dante [SECONDARY]. Switch position [SECONDARY] operating mode Daisy chain connection 4 Redundant connection 4 When Quick Config is used, these switches are disabled. NOTE When the Switch 4 is set to "Redundant connection", the head amp control function (page 15) is only available via the Dante [PRIMARY]. Device features • Switches 5 and 6 (IP address mode) These switches determine how the unit's IP address is set. Switch position IP address mode 56 Auto IP (link local) 56 DHCP 56 56 Static IP Auto (192.168.0.ID) Static IP Manual The IP address is specified from an external device such as R Remote V3. • Switches 7 and 8 (start up mode) These switches determine how the unit starts up during start up mode. When set to "refresh" mode, the settings of the mixer are applied when the unit starts up. When set to "resume" mode, the unit returns to the same state as the last time it was used. Switch position Start up mode 78 REFRESH mode (normal operation) 78 RESUME mode (normal operation) 78 Update mode 78 Diagnostic mode When Quick Config is used, the "normal operation" mode settings are disabled. NOTE • Update mode and diagnostic mode are used when performing maintenance on the unit. Normally you will not use these modes. • Update mode and diagnostic mode can be enabled even when using Quick Config. Normally you will not use these modes. Tio1608-D2 Owner's Manual - 12 -