Yamaha Tio1608-D2 Tio1608-D2 Owners Manual - Page 17
How to read the indicators, Error status
View all Yamaha Tio1608-D2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
English How to read the indicators How to read the indicators You can use the [SYSTEM] and [SYNC] to confirm the unit's status. The indicators can relay operational status, error status, and warnings. Error status If one of the following errors has occurred, the device will not operate. Until the error is resolved, the green [SYSTEM] will be turned off, and all indicators for all I/O channels will continue to flash. In addition, certain errors will cause the red [SYSTEM] to light or flash. [SYSTEM] Description Internal Dante error has occurred. Possible Solution The unit is malfunctioning. Please contact your nearest Yamaha representative. Off Flashes 2 times MAC address setting is damaged and Dante communication is not possible. Off Flashes 3 times Duplicate UNIT ID was found. Make sure each UNIT ID is only used once on the Dante network. Off Lit The following errors affect the settings or the hardware. However, the device will still be usable. The green [SYSTEM] will light, and all indicators for all I/O channels will work normally. In addition, certain errors will cause the red [SYSTEM] to light or flash. [SYSTEM] Description The number of Dante transmit flows exceeded the limit. Possible Solution Reduce the number of flows by, for example, using Dante Controller to change some of the transmit flows to multicast. Lit Flashing Error occurred when communicating with the Turn the unit off and then on again. If this does head amp. not resolve the problem, please contact your nearest Yamaha representative. Lit Flashes 2 times Lit Flashes 3 times Lit Lit Internal memory has been corrupted. If using RESUME mode, turn the unit off and then on again. If this does not resolve the problem, please contact your nearest Yamaha epresentative. You changed the positions of the device setting DIP switches, or changed the Dante settings from Dante Controller. Therefore, the positions of the device setting DIP switches do not match the actual Dante settings. If the Device Lock setting was enabled from Dante Controller, disable the setting, or check the device setting DIP switch positions, and set them to accommodate the current situation. - 17 - Tio1608-D2 Owner's Manual