Zanussi ZBB28650SA Product Manaul - Page 10
Electrical Connection, Door reversibility - installation
View all Zanussi ZBB28650SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Electrical Connection Caution! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Warning! This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. A B 6. Switch on the appliance. The appliance is supplied with a 13 amp plug fitted B. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely. Door reversibility The door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance: C C D B E C Important! The wires in the mains lead are coloured in accordance with the following code: A Green and Yellow: C Brown: D Blue: Earth Live Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter "E" or by the earth symbol or coloured green and yellow. 2. Connect the wire coloured blue to the terminal either marked with the letter "N" or coloured black. 3. Connect the wire coloured brown to the terminal either marked with the "L" or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp E is secure over the outer sheath. 5. Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. 10 1 Loosen the upper pin and remove the spacer. 2 Remove the upper pin and the upper door. 4 Remove the lower door. 5 Loosen the lower pin. 3 Unscrew the pins (B) and spacers (C). On the opposite side: 1 Install the lower pin. 2 Install the lower door. 3 Refit the pins (B) and the spacers (C) on the middle hinge on the opposite side. 4 Install the upper door. 5 Tighten the spacer and the upper pin. www.zanussi.com