Zanussi ZBB28650SA Product Manaul - Page 9
Technical data, Installation - dimensions
View all Zanussi ZBB28650SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Replacing the lamp 1 Disconnect the mains plug from the mains socket. 2 Press on the rear hook and at the same time slide the lamp cover in the direction of the arrow. 3 Replace the lamp with one of the same power and specifically designed for household appliances. (the max- 1 2 imum power is shown on the light lamp cover) 4 Install the lamp cover by sliding it into its original po- sition. 5 Connect the mains plug to the mains socket. 6 Open the door. Make sure that the lamp comes on. Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". Technical data 3. If necessary, replace the defective door gaskets. Contact the Service Center. Dimension of the recess Rising Time Voltage Frequency Height Width Depth 1780 mm 560 mm 550 mm 21 h 230-240 V 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class SN N ST T Ambient temperature +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C www.zanussi.com 9