Zanussi ZBB28650SA Product Manaul - Page 8

Problem The lamp does not work. The compressor operates continually. Water flows on the rear plate of the refrigerator. Water flows into the refrigerator. Water flows on the ground. The temperature in the appliance is too low. The temperature in the appliance is too high. The temperature in the refrigerator is too high. The temperature in the freezer is too high. Possible cause The appliance has no power. There is no voltage in the mains socket. The lamp is in stand-by. The lamp is defective. The temperature is not set correctly. The door is not closed correctly. The door has been opened too frequently. The product temperature is too high. The room temperature is too high. During the automatic defrosting process, frost defrosts on the rear plate. The water outlet is clogged. Products prevent that water flows into the water collector. The melting water outlet does not flow in the evaporative tray above the compressor. The temperature regulator is not set correctly. The temperature regulator is not set correctly. Many products are stored at the same time. There is no cold air circulation in the appliance. Products are too near to each other. Solution Connect a different electrical appliance to the mains socket. Contact a qualified electrician. Close and open the door. Refer to "Replacing the lamp". Set a higher temperature. Refer to "Closing the door". Do not keep the door open longer than necessary. Let the product temperature decrease to room temperature before storage. Decrease the room temperature. This is correct. Clean the water outlet. Make sure that products do not touch the rear plate. Attach the melting water outlet to the evaporative tray. Set a higher temperature. Set a lower temperature. Store less products at the same time. Make sure that there is cold air circulation in the appliance. Store products so that there is cold air circulation. 8 www.zanussi.com