Zanussi ZBB28650SA Product Manaul - Page 11
Ventilation requirements, Installing the appliance - parts
View all Zanussi ZBB28650SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Ventilation requirements The airflow behind the appliance must be sufficient. 5 cm min. 200cm2 min. 200cm2 2 1 4mm 44mm Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: x x A A1 1 If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. 2 Drill the hinge cover A, as shown in figure. Apply the covers A and A1 (in the accessories bag) in to the middle hinge. 3 Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge. 4 Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open the door. Put the lower hinge cover in position. I I 5 Attach the appliance to 6 Remove the correct the niche with 4 screws. part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. www.zanussi.com 11