Zanussi ZDF2020 Product Manaul - Page 11
Care and cleaning - parts
View all Zanussi ZDF2020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Cancelling a delay start: 1. Press and hold the start/cancel button until, the start/ cancel indicator light and delay start indicator light go off. 2. Press the start/cancel button to start the washing programme. End of the washing programme Switch off the appliance in these conditions: • The appliance stops automatically. • The end indicator light comes on. Care and cleaning For better drying results, keep the door ajar for some minutes before you remove the dishes. Let the dishes cool down before you remove them from the appliance. Hot dishes are easily damaged. Removing the load • First remove items from the lower basket, then from the upper basket. • There can be water on the sides and door of the appliance. Stainless steel becomes cool more quickly than the dishes. Warning! Switch the appliance off before you clean the filters. Cleaning the filters Important! Do not use the appliance without the filters. Make sure that the installation of the filters is correct. Incorrect installation will cause unsatisfactory washing results and damage to the appliance. 5 Put the flat filter A in the bottom of the appliance. Install the flat filter correctly under the two guides D. 6 Put the filter system in position. To lock the filter system, turn the handle clockwise until it locks in position. 1 2 Fully clean the filters A, B and C below running wa- ter. 3 4 To remove filters B and C, Remove the flat filter A turn the handle approxi- from the bottom of the ap- mately 1/4 anticlockwise. pliance. Important! Do not remove the spray arms. If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail stick. External cleaning Clean the external surfaces of the appliance and control panel with a damp soft cloth. Only use neutral detergents. Do not use abrasive products, scouring pads or solvents (acetone, trichloroethylene etc...). Frost precautions Caution! Do not install the appliance where the temperature is below 0 °C. The manufacturer is not responsible for damage because of frost. If not possible, empty the appliance and close the door. Disconnect the water inlet hose and remove water from the water inlet hose. 11