Zanussi ZDF3023 Product Manaul - Page 13

Problem Limescale particles on the dishes. Whitish streaks and stains or bluish layers on glasses and dishes. Dry water drop stains on glasses and dishes. The dishes are wet. The dishes are wet and matt. Possible cause Possible solution The spray arms could not turn freely. Make sure that the position of the items in the baskets is correct and does not cause the blockage of the spray arms. The quantity of detergent was not sufficient. Make sure that you add the correct quantity of detergent in the dispenser before you start a programme. There was no detergent in the deter- Make sure that you add detergent in gent dispenser. the dispenser before you start a pro- gramme. The salt container is empty. Make sure that there is dishwasher salt in the salt container. The set level of the water softener is incorrect. Make sure that the set level of the water softener agrees with the water hardness in your area. The cap of the salt container is loose. Tighten the cap. The released quantity of rinse aid is too much. Decrease the released quantity of rinse aid . The quantity of detergent was too much. Make sure that you add the correct quantity of detergent in the dispenser before you start a programme. The released quantity of rinse aid was not sufficient . Increase the released quantity of rinse aid. The quality of the detergent can be the cause. Try a different brand of detergent. The programme had no drying phase. Set a programme with the drying phase. The rinse aid dispenser is empty. Make sure that there is rinse aid in the rinse aid dispenser. The quality of the rinse aid can be the Try a different brand of rinse aid. cause. The quality of the combi detergent tablets can be the cause. • Try a different brand of combi detergent tablets. • Activate the rinse aid dispenser and use the rinse aid together with the combi detergent tablets. Activating the rinse aid dispenser with the multitab function activated The appliance must be in setting mode. Refer to 'SETTING AND STARTING A PROGRAMME'. 1. Make sure that the programme marker on the programme knob is aligned with the off position. 2. Press and hold Start. At the same time turn the programme knob counterclockwise until the programme marker is aligned with the first programme on the control panel. www.zanussi.com 13