Zanussi ZDT12002FA Product Manaul - Page 10

Troubleshooting

Get Zanussi ZDT12002FA PDF manuals and user guides View all Zanussi ZDT12002FA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

A 3 To remove filters (B) and (C), turn the handle counterclockwise and remove. Pull apart filter (B) and (C). Wash the filters with water. 4 Remove filter (A). Wash the filter with water. D An incorrect position of the filters can cause bad washing results and damage to the appliance. Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object. External cleaning Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads or solvents. A 5 Put filter (A) to its initial position. Make sure that it assembles correctly under the two guides (D). 6 Assemble filters (B) and (C). Put them into position in filter (A). Turn the handle clockwise until it locks. Troubleshooting The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the Service. With some problems, some indicators flash continuously and/or intermittently at the same time to show an alarm code. Alarm code • The indicator of the set programme flashes continuously. • The end indicator flashes 1 time intermittently. • The indicator of the set programme flashes continuously. • The end indicator flashes 2 times intermittently. Problem The appliance does not fill with water. The appliance does not drain the water. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
3
To remove filters (
B
) and
(
C
), turn the handle coun-
terclockwise and remove.
Pull apart filter (
B
) and
(
C
). Wash the filters with
water.
A
4
Remove filter (
A
). Wash
the filter with water.
D
A
5
Put filter (
A
) to its initial
position. Make sure that it
assembles correctly under
the two guides (
D
).
6
Assemble filters (
B
) and
(
C
). Put them into position
in filter (
A
). Turn the han-
dle clockwise until it
locks.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove remain-
ing parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Troubleshooting
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
With some problems, some indicators flash continuously
and/or intermittently at the same time to show an alarm
code.
Alarm code
Problem
•
The indicator of the set programme flashes continu-
ously.
•
The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
•
The indicator of the set programme flashes continu-
ously.
•
The end indicator flashes 2 times intermittently.
The appliance does not drain the water.
10