Zanussi ZDT12002FA Product Manaul - Page 11

Alarm code • The indicator of the set programme flashes continuously. • The end indicator flashes 3 times intermittently. Problem The anti-flood device is on. Warning! Deactivate the appliance before you make the checks. Problem The programme does not start. The appliance does not fill with water. The appliance does not drain the water. Possible cause The mains plug is not connected in the mains socket. The appliance door is open. The fuse in the fuse box is damaged. The water tap is closed. Possible solution Connect the mains plug. Close the appliance door. Replace the fuse. Open the water tap. The water pressure is too low. Contact your local water authority. The water tap is clogged or there is lime- Clean the water tap. scale on it. The filter in the water inlet hose is clog- Clean the filter. ged. The water inlet hose has a kink or a bend. Make sure that the position of the hose is correct. The anti-flood device is on. There are water leakages in the appliance. Close the water tap and contact the Service. The sink spigot is clogged. Clean the sink spigot. The water drain hose has a kink or a bend. Make sure that the position of the hose is correct. After the checks are completed, activate the appliance. The If the problem occurs again, contact the Service. programme continues from the point of interruption. If other alarm codes show, contact the Service. The washing results and drying results are not satisfactory Problem The dishes are not clean. Possible cause The filters are clogged. The filters are not correctly assembled and installed. The spray arms are clogged. Possible solution Clean the filters. Make sure that the filters are correctly assembled and installed. Remove remaining soil with a thin pointed object. 11