Zanussi ZWG6120K Product Manaul - Page 14

1. 2. 1 2 3 3. 4. 5. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 6. When no more water flows, install the inlet hose and the drain hose again. 45° 20° Frost precautions If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Warning! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Remove the water inlet hose 4. Remove the drain hose from the rear support and unhook it from sink or spigot Troubleshooting The start of the appliance does not occur or the appliance stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the Service. During appliance operation it is possible that the red indicator of button Start / Pause flashes and one of the indicators comes on, to show that the appliance does not operate: • Washing : the appliance does not fill with water. • Extra Rinse : the appliance does not drain the water. • End : the appliance door is open or not closed correctly. Problem The appliance does not start. Possible solution Make sure that the mains plug is connected in the mains socket. 14 www.zanussi.com