Zanussi ZWG6120K Product Manaul - Page 9

Temperature button (Temp.) Press this button to change the default temperature. Symbol - cold water. Spin button (Spin) With this button you can set one of these options: Automatic spin reduction Set this function to decrease the spin seed to a half, but not less than 400 rpm. Rinse hold Set this function to prevent the laundry creases. There is a water in the drum when the programme is completed. Super quick button (Super Quick) Press this button to decrease the programme duration. Before first use Set this function for items with light soil or items to refresh. Delay start button (Delay Start) Press this button to delay the start of a programme by 9, 6 or 3 hours. Extra Rinse Press the button "Spin" and together the button "Super Quick" for some seconds to add the rinsing phase to a programme. The indicator Extra Rinse is on. This function stays permanently on when you deactivate the appliance. To remove this function press the same buttons again. Use this function for persons allergic to detergents and in areas where the water is soft. Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the Daily use highest temperature without laundry. This removes all possible dirt from the drum and the tub. 1. Open the water tap. 2. Connect the mains plug to the mains sock- et. 3. Put the laundry in the appliance. 4. Use the correct quantity of detergent and additives. 5. Set and start the correct programme for the type of laundry and soil. Loading the laundry 1. Open the appliance door. 2. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. 3. Close the door. Caution! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. Using the detergent and additives www.zanussi.com 9