Zanussi ZWG6120K Product Manaul - Page 16

Problem Possible solution Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. Add more laundry in the drum. The load may be too small. The appliance fills with Make sure that the drain hose is in the correct position. The end of the hose may water and drain immedi- be is too low. Refer to 'Installation instruction'. ately. The washing results are Increase the detergent quantity or use a different detergent. not satisfactory. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. Service We recommend the use of original spare parts. Technical information When contacting the Service, make sure that these data are available. You can find the information on the rating plate: model (Mod.), PNC (Prod.No.), Serial number (Ser.No.). Dimensions Width / Height / Depth Total depth Electrical connection: Voltage Overall power Fuse Frequency Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure Minimum Maximum Water supply 1) Maximum load Cotton Spin speed Maximum 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 600 / 850 / 501 mm 519 mm 230 V 2100 W 13 A 50 Hz IPX4 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Cold water 6 kg 1000 rpm (ZWG 6100K) 1200 rpm (ZWG 6120K) 16 www.zanussi.com