Zenith L27W46 Operating Guide - Page 12

Installation External Equipment Connections Continued VCR Setup - In Video mode, TV automatically reverts to TV mode if the FCR button or FLASHBK buttons are pressed. Connection 1 Set VCR switch to 3 or 4 and then tune TV to the same channel number. Connection 2 1. Connect the audio/video output jacks on VCR to the corresponding input jacks on the TV. When connecting the TV to a VCR, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). 2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual.) 3. Use the TV/VIDEO button on the remote control to select Video. (If connected to S-VIDEO on side panel, select the S-Video external input source.) 1 2 Typical Antennas ANT IN ANT OUT S-VIDEO OUT Direct CH3 IN CH4 VIDEO (R) AUDIO(L) Connection 1 VCR Side Panel 2 Typical Antennas ANT IN ANT OUT S-VIDEO OUT Direct Connection CH3 IN CH4 VIDEO (R) AUDIO(L) 2 1 VCR Cable TV Setup - After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming. - For further cable TV information, contact a local cable service provider. Connection 1 1. Select 3 or 4 with channel switch on cable box. 2. Tune the TV channel to the same selected output channel of cable box. 3. Select channels at the cable box or with the cable box remote control. Connection 2 1. Connect the audio/video output jacks on Cable Box to the corresponding input jacks on the TV. When connecting the TV to Cable Box, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). 2. Use the TV/VIDEO button on the remote control to select Video. 3. Select channels with the cable box remote control. 2 1 (R) AUDIO (L) VIDEO TV VCR RF Cable Cable Box 12