Zenith SL-4305-WH User Guide - Page 3

Bare Ground Wire Ground Screw Pigtail (not supplied) Fixture Bare Ground Wire Metal Junction Box White to White Black to Black Recommended Grounding Method Black to Black White to White Ground to Ground One Motion Sensing Light Ground to Ground Black to Black White to White Two Motion Sensing Lights (Working Independently) Other Wiring Options This fixture can be wired to control another standard or motion sensing light fixture(s). See the following wiring diagrams for proper connections. Note: All wiring should be run in accordance with the National Electrical Code through conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of the system. When controlling an additional light fixture(s), the maximum wattage of the motion sensor on this fixture should be observed. See illustration below for an example of a maximum lamp wattage load calculation. Maximum Load for Motion Sensor - 500 Watts Maximum Lamp Wattage Rating for Light Fixture - 100 Watts CONTROLLING Fixture Maximum Lamp Wattage Rating for Light Fixture - 100 Watts CONTROLLED Fixture 1 Maximum Lamp Wattage Rating for Light Fixture - 100 Watts CONTROLLED Fixture 2 TOTAL Load for Motion Sensor - 300 Watts (200 Watts Remaining) IMPORTANT: When determining the maximum lamp wattage rating of the fixture to be controlled, refer to the maximum lamp wattage label on the fixture and not the wattage rating on the lamp(s) currently installed in the fixture. White to White Black to Black Red to Black Ground to Ground 598-1184-04 Motion Sensing Light Standard Light Fixture Wiring Motion Sensing Light to Control Standard Fixture