Zenith SL-4305-WH User Guide - Page 6
Troubleshooting Guide - where
UPC - 016963430556
View all Zenith SL-4305-WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE Light will not 1. Light switch is turned off. come on. 2. Bulbs are loose or burned out. 3. Fuse is blown or circuit breaker is turned off. 4. Daylight turn-off is in effect (re- check after dark). 5. Incorrect circuit wiring, if this is a new installation. Light comes on 1. Sensor may be installed in a in daylight. relatively dark location. 2. Sensor is in Test. (Set control switch to an ON-TIME position.) Light comes on 1. Sensor may be sensing small for no apparent animals or automobile traffic. reason. (Reduce sensitivity.) 2. Sensitivity is set too high. (Re- duce sensitivity.) SYMPTOM POSSIBLE CAUSE Light stays on 1. There is a heat source like an continuously. air vent, dryer vent, or brightly- painted, heat-reflective surface in the coverage area. (Install shield on sensor in the direction of heat source.) 2. Sensor is in Manual Mode.(Switch to Auto.) 3. Sensitivity is set too high.(Reduce sensitivity.) Light flashes on 1. Heat being reflected from other and off. objects may be affecting the sen- sor. (Reduce sensitivity.) 2. Sensor is in the Test mode. (While in TEST mode, light only stays on for 5 seconds.) Light does not 1. Nearby large, light-colored objects stay on in Man- reflecting light may trigger the ual mode. shut-off feature. Do not point other lights at the sensor. 598-1184-04