Zenith SL-4305-WH User Guide - Page 4
Testing, Install Fixture Base To, Junction Box - light bulb
UPC - 016963430556
View all Zenith SL-4305-WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
White to White Black to Black Black to Red and Black Red to Black Ground to Ground Motion Sensing Light Controlled Motion Sensing Light Wiring Motion Sensing Light to Control Another Motion Sensing Light It is also possible to wire two motion sensing lights so that either unit will turn on both lights at the same time (dual controlled system). It is recommended that only people with electrical wiring experience attempt this configuration. Please call our customer service number (1-800-858-8501) before attempting this wiring. If the dual controlled wiring is not done correctly, it can destroy both motion sensing fixtures and void your warranty. Install Fixture Base to Junction Box 1. Push wires into the junction box. 2. Slide light fixture base onto fixture screws and tighten decorative nuts snugly against the base. 3. Install four candelabra base light bulbs (25 Watts maximum each). 4. Refer to TESTING section before installing cover. 5. After switches are set and testing is complete, use the 2 decorative nuts to install the cover. Junction Box Testing 1. Turn on the circuit breaker and light switch. Note: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on wait 1 1/2 minutes. 2. Set the SENSITIVITY switch to the "M" position and the ON-TIME switch to the TEST position. SENSITIVITY SENSITIVITY LO - M - HI TESOTN1-T5IM1E0 MIN LO - M - HI Sensor Lens TEST 1 5 10 MIN ON-TIME 3. Walk through the coverage area noting where you are when the lights turn on. In TEST mode, light will stay on for only 5 seconds then turn off. 4. Adjust the SENSITIVITY to increase or decrease the range as needed. Too much sensitivity may cause false triggering due to heat sources in the coverage area (see Adjustment of Coverage Area or Troubleshooting section). 5. Set the amount of TIME you want the light to stay on after motion is detected (1, 5, or 10 minutes). 360° 8 ft. (2.4 m) Decorative Nut SENSITIVITY LO - M - HI TESOTN1-T5IM1E0 MIN Fixture Screw 25 Watt Candelabra Base Bulb 30 Feet (9.1 m) in all Directions Maximum Range Coverage Angle* (Top View) * Without lens shield installed. 598-1184-04