Zenith SL-5410-GR User Guide - Page 4
Specifications
UPC - 016963541009
View all Zenith SL-5410-GR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Avoid aiming the control at: • Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering. • Areas where pets or unwanted traffic may trigger the control. • Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the sensor. 8 ft. (2.4 m) 110° 60 ft. (18.3 m) Maximum Range Maximum Coverage Angle The detector is most sensitive to motion across its field of view. Motion Motion Sensor Least Sensitive Most Sensitive NOTE: If fixture is mounted higher than 8 ft.(2.4 m), aiming the sensor down will reduce coverage distance. ❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor. Clamp Screw ❒ Walk through the coverage area noting where you are when the lights turn on. Move the sensor head up, down, or sideways to change the coverage area. Keep the sensor at least 1" (2.5 cm) away from the lamps. ❒ Adjust the SENSITIVITY as needed. Too much sensitivity may increase false triggering. Ball Joint Aim Sensor Down for Short Coverage ❒ Secure the sensor head by tightening the clamp screw. Do not overtighten the screw. ❒ Set the amount of TIME you Aim Sensor Higher for Long Coverage want the lights to stay on after motion is detected (1, 5, or 10 minutes). Warning - Risk of fire. Do not aim the lamps at a combustible surface within 3 ft. (1 m). SPECIFICATIONS Range Up to 60 ft. (18.3 m) [varies with surrounding temperature]. Sensing Angle Up to 110° Electrical Load Up to 300 Watt Maximum In- candescent [Up to 150 Watt maximum each lamp holder.] Power Requirements. . 120 VAC, 60 Hz Operating Modes. . . . . TEST, AUTO and MANUAL MODE Time Delay 1, 5, 10 minutes Range Adjustable HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold. 598-1303-01