Zenith SL-6107-WH User Guide - Page 5
Replace Other Switch. - wiring brown
UPC - 169636107122
View all Zenith SL-6107-WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
INSTALLATION 2. Replace Other Switch. ❐ Turn the power off at the circuit breaker. ❐ Remove and disconnect the old switch. Note: If you can't tell which wire is common, etc., connect the wires in the following steps as best you can, then follow the test on the next page. ❐ Connect the black motion sensor wire to the common wire. ❐ Connect the brown motion sensor wire to the jumpered wire on the remote switch. ❐ Connect the red motion sensor wire to the non-jumpered wire. ❐ Connect the green motion sensor wire to the ground wire. Non-Jumpered Jumpered Wire Brown Red Wire Removed from Common OFF AUTO ON Ground Wire (Green or Bare Wire) Green Black Connect the SL-6107 to Existing Wiring 595-4514-15 --
-5-
595-4514-15
2. Replace Other Switch.
❐
Turn the power off at the circuit breaker.
❐
Remove and disconnect the old switch.
Note:
If you can’t tell which wire is common, etc., connect the wires
in the following steps as best you can, then follow the test on the
next page.
❐
Connect the
black
motion sensor wire to the
common
wire.
❐
Connect the
brown
motion sensor wire to the
jumpered
wire on
the remote switch.
❐
Connect the
red
motion sensor wire to the
non-jumpered
wire.
❐
Connect the
green
motion sensor wire to the
ground
wire.
Connect the SL-6107 to Existing Wiring
INSTALLATION
N
O
AUTO
OFF
Jumpered Wire
Brown
Wire Removed
from Common
Ground Wire
(Green or Bare Wire)
Black
Green
Non-Jumpered
Red