Zenith SL-6107-WH User Guide - Page 7
Troubleshooting Wiring Connections - motion sensor
UPC - 169636107122
View all Zenith SL-6107-WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
INSTALLATION ❐ Mount the SL-6107 into the junction box with the two junction box screws. ❐ Turn the circuit breaker back on. ❐ Preset the controls: Time to minutes, Photo Adjustment fully clockwise. Cover the lens with masking tape. ❐ With the motion sensor in the "ON" position, turn the remote switch on and off several times. Go to step 1, 2, or 3, depending on results. Troubleshooting Wiring Connections * Turn power off before rewiring! 1. If light does not turn on: Exchange* ➯ Control's Red ⇔ Black wires. ➯ Test again. Go to 2 or 3. 2. If light turns on in only one position ➯ of remote switch: Exchange* Control's Red ⇔ Brown wires. ➯ Test again. Go to 1 or 3. If light turns Set sensor to "AUTO". Wait for the 3. on with remote switch in either ➯ unit to warm up (up to 1 min.). If the remote switch can turn the lights on, position: it's OK. Otherwise: ➯ 595-4514-15 Exchange* Control's Black ⇔ Brown wires. Remove the tape. Go to the next page. --