ZyXEL PLA4201 User Guide - Page 14
Power, Ethernet, HomePlug, RESET/ENCRYPT, RESET, ENCRYPT, Installing the Utility - guide
View all ZyXEL PLA4201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 2 Installing the Utility When you plug the PLA4201 v2 into an electric socket, it waits for an Ethernet connection. When no connection is detected after sixty (60) seconds, the Power LED blinks indicating that it is going into Low Power mode. The same process occurs when you disconnect the PLA4201 v2 from a previously working Ethernet connection. Sixty (60) seconds after disconnecting the Ethernet cable, the PLA4201 v2's Power LED blinks signalling that it is going into Low Power mode. The Ethernet and HomePlug LEDs are turned off in Low Power mode. While in Low Power mode, you cannot use the RESET/ENCRYPT button. To enable the RESET/ ENCRYPT button again, you have to connect the PLA4201 v2's Ethernet cable to a computer/ notebook or modem/router first. The PLA4201 v2 wakes up from Low Power mode and you can start using the RESET/ENCRYPT button. Low Power mode is enabled by default. 14 PLA4201 v2 User's Guide