ZyXEL PLA6456 User Guide - Page 23

Label, Description - firmware update

Get ZyXEL PLA6456 PDF manuals and user guides View all ZyXEL PLA6456 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Chapter 3 Web Configurator Figure 11 Device Screen The following table describes the labels in this screen. After you see the firmware updating screen, wait two minutes before logging into the PLA again. Table 8 Device Screen LABEL DESCRIPTION Hardware information Device name This field displays the PLA system name. It is used for identification. Device description This field shows that this is a G.hn bridge PLA. Device manufacturer This field displays the manufacturer of this PLA. Serial number This field displays the manufacturer assigned number of this PLA. MAC address This field displays the Ethernet adapter MAC (Media Access Control) address of this PLA. HW version This field displays the hardware version number of this PLA. Software information FW version This field displays the current version of the firmware inside this PLA. System uptime This field displays how long the PLA has been running since it last started up. The PLA starts up when you plug it in, or when you reset it. Security New Configuration password Type your new Web Configurator password. The password must consist of 6 to 64 characters, including 0 to 9 and a to z (case sensitive). Note that as you type a password, the screen displays a (*) for each character you type. Then click Ok. After you change the password, use the new password to access the PLA. HTTP SW update PLA6456 User's Guide 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Chapter 3 Web Configurator
PLA6456 User’s Guide
23
Figure 11
Device Screen
The following table describes the labels in this screen. After you see the firmware updating screen, wait
two minutes before logging into the PLA again.
Table 8
Device Screen
LABEL
DESCRIPTION
Hardware information
Device name
This field displays the PLA system name. It is used for identification.
Device
description
This field shows that this is a G.hn bridge PLA.
Device
manufacturer
This field displays the manufacturer of this PLA.
Serial number
This field displays the manufacturer assigned number of this PLA.
MAC address
This field displays the Ethernet adapter MAC (Media Access Control) address of this PLA.
HW version
This field displays the hardware version number of this PLA.
Software information
FW version
This field displays the current version of the firmware inside this PLA.
System uptime
This field displays how long the PLA has been running since it last started up. The PLA starts up
when you plug it in, or when you reset it.
Security
New
Configuration
password
Type your new Web Configurator password. The password must consist of 6 to 64 characters,
including 0 to 9 and a to z (case sensitive). Note that as you type a password, the screen
displays a (*) for each character you type. Then click
Ok
. After you change the password, use
the new password to access the PLA.
HTTP SW update