ZyXEL ZyWALL USG 20 User Guide - Page 299
DiffServ, DSCP Marking and Per-Hop Behavior, Finding Out More - zywall usg 20w qos
View all ZyXEL ZyWALL USG 20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 299 highlights
Chapter 13 Policy and Static Routes • Policy routes are only used within the ZyWALL itself. Static routes can be propagated to other routers using RIP or OSPF. • Policy routes take priority over static routes. If you need to use a routing policy on the ZyWALL and propagate it to other routers, you could configure a policy route and an equivalent static route. DiffServ QoS is used to prioritize source-to-destination traffic flows. All packets in the same flow are given the same priority. CoS (class of service) is a way of managing traffic in a network by grouping similar types of traffic together and treating each type as a class. You can use CoS to give different priorities to different packet types. DiffServ (Differentiated Services) is a class of service (CoS) model that marks packets so that they receive specific per-hop treatment at DiffServ-compliant network devices along the route based on the application types and traffic flow. Packets are marked with DiffServ Code Points (DSCPs) indicating the level of service desired. This allows the intermediary DiffServ-compliant network devices to handle the packets differently depending on the code points without the need to negotiate paths or remember state information for every flow. In addition, applications do not have to request a particular service or give advanced notice of where the traffic is going. DSCP Marking and Per-Hop Behavior DiffServ defines a new DS (Differentiated Services) field to replace the Type of Service (TOS) field in the IP header. The DS field contains a 2-bit unused field and a 6-bit DSCP field which can define up to 64 service levels. The following figure illustrates the DS field. DSCP (6 bits) Unused (2 bits) DSCP is backward compatible with the three precedence bits in the ToS octet so that non-DiffServ compliant, ToS-enabled network device will not conflict with the DSCP mapping. The DSCP value determines the forwarding behavior, the PHB (Per-Hop Behavior), that each packet gets across the DiffServ network. Based on the marking rule, different kinds of traffic can be marked for different kinds of forwarding. Resources can then be allocated according to the DSCP values and the configured policies. Finding Out More • See Section 6.5.5 on page 96 for related information on the policy route screens. • See Section 7.12 on page 145 for an example of creating a policy route for using multiple static public WAN IP addresses for LAN to WAN traffic. ZyWALL USG 20/20W User's Guide 299