1998 Buick Skylark Owner's Manual - Page 95

Flash-To-Pass Feature (Except Canada) This feature lets you use your high-beam headlamps to signal a driver front of you that you want to pass. in It works even if your headlamps off. are To use it, pull the turn signaVmultifunction beam lever so toward you a little (but not far that you hear a click). If your headlamps areoff, your high-beam headlamps will turn on. They'll stay onas long as you hold the off. lever there. Release the lever to turn them If your headlamps are on, but on low beam, the system works normally. Just pull the lever untilclicks. Your it headlamps will shift to high beam and stay there. To return to low beam, pull the lever toward until it just you clicks again. Windshield Wipers You control the windshield wipers by rotating the outer portion of the switch. For a single wiping cycle, move the band toward you. Hold it down until the wipers start, then let go. The If wipers will stop after one cycle. you want more to cycles, hold the lever down MIST longer. For steady wiping at low speed, move the band to LO. For high-speed wiping, move the band further up. To stop the wipers, move band t.0 OFF. the 2-34