2010 Chevrolet Silverado 1500 Regular Cab Owner's Manual - Page 484
2010 Chevrolet Silverado 1500 Regular Cab Manual
Page 484 highlights
Do not top off the brake fluid. Adding fluid does not correct a leak. If fluid is added when the linings are worn, there will be too much fluid when new brake linings are installed. Add or remove brake fluid, as necessary, only when work is done on the brake hydraulic system. The fluid level should be above MIN. If it is not, have the brake hydraulic system checked to see if there is a leak. { WARNING: If too much brake fluid is added, it can spill on the engine and burn, if the engine is hot enough. You or others could be burned, and the vehicle could be damaged. Add brake fluid only when work is done on the brake hydraulic system. See "Checking Brake Fluid" in this section. Refer to the Maintenance Schedule to determine when to check the brake fluid. See Scheduled Maintenance on page 7‑3. After work is done on the brake hydraulic system, make sure the level is above the MIN but not over the MAX mark. What to Add Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids and Lubricants on page 7‑13. Always clean the brake fluid reservoir cap and the area around the cap before removing it. This helps keep dirt from entering the reservoir. Checking Brake Fluid Check brake fluid by looking at the brake fluid reservoir. See Engine Compartment Overview on page 6‑16. 6-40