2011 Chevrolet Malibu Owner's Manual - Page 46

2-16 Keys, Doors and Windows To stop the window while it is lowering, pull the front of the switch momentarily. To raise the window, pull and hold the front of the switch. To program the driver window, follow these steps: 1. With the ignition in ACC/ ACCESSORY, ON/RUN, or when Retained Accessory Power (RAP) is active, close all doors. 2. Press and hold the power window switch until the window is fully open. 3. Pull the power window switch up until the window is fully closed. 4. Continue holding the switch up for approximately two seconds after the window is completely closed. The window is now reprogrammed. Power Windows Express-Up Window On windows with this feature, pull the switch up to the second position and release the switch to activate the express-up feature. To stop the window as it is going up, pull up or press down briefly on the switch again. The power window switches are located on the armrest on the driver's door. In addition, there is a switch on each passenger door. Programming the Power Windows If the battery on the vehicle has been recharged, disconnected, or is not working, the driver power window will need to be re-programmed for the express-up feature to work. Replace or recharge the vehicle's battery before reprogramming. Express-Down Window The driver window has an express-down feature. This switch is labeled AUTO. Press the front all the way down and release, to automatically lower.