2005 Chrysler Pacifica Owner's Manual - Page 231
2005 Chrysler Pacifica Manual
Page 231 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 231 • Press the recirculation button until the indicator light remains lit. • The selection will be stored when the ignition switch is turned OFF or if the "POWER" button is pressed. If the recirculation indicator light is lit, the recirculation mode will not reset when the engine is started. If the recirculation indicator light is not lit, the recirculation mode will reset to the outside air mode when the engine is started. The programmed status can be changed back and forth by following the above mentioned procedure. As additional protection against odor build-up in the air conditioner-heater housing, the recirculation control will automatically bring in a small amounts of outside air, if the recirculation feature is on for more than 10 minutes. You can disable this feature by using one of the following procedures: 1. Pressing the recirculation button twice within two seconds will temporarily disable this feature. When the ignition switch is turned OFF, the recirculation mode will be enabled the next time the ignition switch is turned ON. 2. You can disable this feature permanently by following the procedure below: • Turn the ignition switch to the OFF position. • Set the mode control to "BI-LEVEL". • Depress and hold in the "POWER" button. • Start the engine, and continue to hold in the "POWER" button until the indicator light starts flashing repeatedly. • Press the recirculation button until the indicator light remains lit. 4