2008 Chrysler Sebring Owner Manual Convertible - Page 158

158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 4. Press and hold the just-trained HomeLink௡ button and observe the indicator light. If the indicator light stays on constantly, programming is complete and the garage door (or device) should activate when the HomeLink௡ button is pressed. If the indicator light blinks rapidly for two seconds, and then turns to a constant light, continue with programming for Rolling Code. 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "learn" or "training" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open & close the door). 1 - Garage Door Opener 2 - Training Button 6. Firmly press and release the "learn" or "training" button. The name and color of the button may vary by manufacturer. NOTE: There are 30 seconds in which to initiate the next step after the "Learn" button has been pressed.