2008 Chrysler Sebring Owner Manual Convertible - Page 183

UNDERSTANDING YOUR INSTRUMENT PANEL 183 The operation of the Brake Warning Light can be checked by turning the ignition switch from the OFF position to the ON position. The light should illuminate for approximately two seconds. The light should then turn off unless the parking brake is applied or a brake fault is detected. If the light does not illuminate, have the light inspected by an authorized dealer. The light also will turn on when the parking brake is applied with the ignition switch in the ON position. NOTE: This light shows only that the parking brake is applied. It does not show the degree of brake application. 20. Turn Signal Indicators The arrows will flash in unison with the exterior turn signal, when using the turn signal lever. 21. Front Fog Light Indicator - If Equipped This light shows when the front fog lights are ON. 22. Electronic Stability Program (ESP) Indicator Light The yellow ESP/BAS malfunction indicator light will turn on when the ignition switch is turned to the "ON" position. The light should go out with the engine running. If the light remains on after several ignition cycles, and you have driven the vehicle several miles at speeds greater than 30 mph (48 km/h), and the ESP is synchronized (refer to Synchronizing ESP), see your authorized dealer as soon as possible to have the problem diagnosed and corrected. 23. Anti-Lock Warning Light (ABS) This light monitors the ABS. This light will come on when the ignition key is turned to the ON position and may stay on for as long as four seconds. If the ABS light remains on or comes on during driving, it indicates that the Anti-Lock portion of the brake system is not functioning and that service is required, however, 4