2008 Dodge Ram 2500 Pickup Owner Manual Diesel - Page 158
2008 Dodge Ram 2500 Pickup Manual
Page 158 highlights
156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage door or gate motor. If you are having difficulties programming a garage door opener or a gate operator, replace "Programming HomeLink" Step 3 with the following: 3. Continue to press and hold the HomeLink button while you press and release - every two seconds ("cycle") your hand-held transmitter until HomeLink has successfully accepted the frequency signal. The EVIC display will change from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." If you unplugged the device for training, plug it back in at this time. Then proceed with Step 4 under "Programming HomeLink" earlier in this section. Using HomeLinkா To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.) The hand-held transmitter of the device may also be used at any time. Reprogramming A Single HomeLinkா Button To reprogram a channel that has been previously trained, follow these steps: 1. Turn the ignition switch to the ON/RUN position. 2. Press and hold the desired HomeLink button for 20 seconds until the EVIC display states "CHANNEL # TRAINING." Do not release the button.