2008 Dodge Ram 2500 Pickup Owner Manual Diesel - Page 31
2008 Dodge Ram 2500 Pickup Manual
Page 31 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 8. If a chime is not heard, the program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. Auto Unlock On Exit - If Equipped This feature unlocks all of the doors of the vehicle when any door is opened. This will occur only after the vehicle has been shifted into the PARK position after the vehicle has been driven (shifted out of PARK and all doors closed). Auto Unlock On Exit Programming - If Equipped Customer programming sequence to enable or disable the Auto Unlock Feature: • For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to "Personal Settings (Customer Programmable Features)" under "Overhead Console with Electronic Vehicle Information Center (EVIC) - If Equipped" in Section 3. • For vehicles not equipped with the EVIC, perform the following procedure: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt. (fastening the seat belt will cancel any chimes that may be confusing during this programming procedure.) 3. Insert the key into the ignition. 4. Within 15 seconds, cycle the key from the LOCK position to the ON/RUN position a minimum of four times, ending in the LOCK position (do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the UNLOCK direction. 6. A single chime will sound to indicate the feature has been changed. 2