2010 Dodge Avenger Owner Manual - Page 124
2010 Dodge Avenger Manual
Page 124 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 123 Place the handheld transmitter 1 to 3 in (3 to 8 cm) away • After training a HomeLink channel, if the garage from the HomeLink button you wish to program while door does not operate with HomeLink and the gakeeping the indicator light in view. rage door opener was manufactured after 1995, the garage door opener may have a rolling code. If so, 3. Simultaneously press and hold both the chosen proceed to Step 5 "Programming A Rolling Code HomeLink button and the handheld transmitter button System." until the HomeLink indicator changes from a slow to a rapidly blinking light, then release both the HomeLink 4. Press and hold the just-trained HomeLink button and handheld transmitter buttons. and observe the indicator light. Watch for the HomeLink indicator to change flash rates. If the indicator light stays on constantly, programming is When it changes, it is programmed. It may take up to complete and the garage door (or device) should activate 30 seconds or longer in rare cases. The garage door may when the HomeLink button is pressed. open and close while you train. If the indicator light blinks rapidly for two seconds and NOTE: then turns to a constant light, proceed to Step 5 "Pro• Some gate operators and garage door openers may gramming A Rolling Code System." require you to replace Step 3 with procedures noted in 5. Programming A Rolling Code System the "Gate Operator/Canadian Programming" section. At the garage door opener motor (in the garage), locate the "Learn" or "Training" button. 3