2010 Dodge Avenger Owner Manual - Page 157

156 UNDERSTANDING YOUR INSTRUMENT PANEL tighten the fuel filler cap properly and press the odometer reset button to turn off the "gASCAP" message. (Refer to "Onboard Diagnostic System - OBDII" in "Maintaining Your Vehicle" for further information). If the problem continues, the message will appear the next time the vehicle is started. See your authorized dealer service center as soon as possible. To turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance) perform the following procedure: 1. Turn the ignition switch to the ON position (Do not start the engine). CHAngE OIL 2. Fully depress the accelerator pedal slowly 3 times Your vehicle is equipped with an engine oil change within 10 seconds. indicator system. The "CHAngE OIL" message will flash in the instrument cluster odometer for approximately 3. Turn the ignition switch to the LOCK position. 12 seconds after a single chime has sounded to indicate NOTE: If the indicator message illuminates when you the next scheduled oil change interval. The engine oil start the vehicle, the oil change indicator system did not change indicator system is duty cycle based, which reset. If necessary repeat this procedure. means the engine oil change interval may fluctuate dependent upon your personal driving style. 4. For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to "Electronic Vehicle Unless reset, this message will continue to display each Information Center (EVIC)". time you turn the ignition switch to the "ON" position.