2001 Ford Explorer Sport Trac Owner Guide 6th Printing - Page 26

Controls and features Normal Operation If an "up" command is selected and the ignition is switched to OFF or START during window travel, the window will: 1. stop if it is between the vent position and fully closed or 2. continue to move up to the vent position if it is between vent and fully open. If a "down" or "vent" command is selected and the ignition is switched to OFF or START during window travel, the window will move to the fully open or vent position, respectively, and then stop. The "down" command is the only one allowed after the ignition has been switched to OFF or START while the window is moving. Bounce-Back When the back window is moving upward and an obstacle interferes with the window's movement, the back window will reverse direction and move toward the fully open position. This is known as "bounce-back". Security Override If, during a bounce-back condition, the control is held in the clockwise ("up") direction for at least two seconds, the back window will travel up with no bounce-back protection. If the control is released before the window reaches fully closed or the ignition is switched to OFF or START, the back window will reverse direction with bounce-back re-enabled. The following are possible reasons for using the security override: • Ice on the window causing a restriction. • Window unexpectedly reverses. Position recovery mode If the window fails to operate in "normal" operation mode, the control can be turned and held in the active position (up or down window direction) which will move the window in increments of approximately 15mm (0.6 inches) in the selected direction. (The "vent" feature is inoperable in this mode.) This feature allows the window to be closed. Once the window has reached the full closed, the window should again operate in "normal" operation mode. If the window still does not operate correctly, see your dealer for service. 26