2000 Nissan Maxima Owner's Manual - Page 110

FM-AM radio operation FM-AM band select: Push the FM-AM band select button to listen to the radio and tune in the desired station. Pushing the FM-AM band select button will change the band FM1, FM2 or AM. The FM stereo indicator, ST illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. TUNE (Tuning): SAA0235 Adjusting tone quality and speaker balance: To adjust BASS⋅TREB⋅FADER⋅BAL (Bass, Treble, Fader, Balance), press the AUDIO button until the desired mode (BAS, TRE, FAD or BAL) appears in the display. Press the or button to adjust BASS and TREB to the desired level. Use the or button to adjust FADER or BAL modes. FADER adjusts the sound level between the front and rear speakers and BAL adjusts the sound level between the right and left speakers. After 10 seconds, the radio or cassette tape display reappears. Once the sound quality is set to the desired level, press the AUDIO button repeatedly until the radio or cassette tape display appears. WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Push either manual tuning button . SEEK/SCAN tuning: Push the SEEK/SCAN tuning button or for less than 1.5 seconds. SEEK tuning begins from high to low or low to high frequencies and stops at the next broadcasting staHeater, air conditioner and audio systems Radio/Cassette tape priority mode In this mode, the radio station illuminates in the display during radio operation. During cassette tape operation, TAPE illuminates in the display. or 4-15