2008 Nissan Versa Owner's Manual - Page 151

only be installed in vehicles that were factory pre-wired for satellite radio. Satellite radio is not available in Alaska, Hawaii and Guam. Audio main operation PWR and VOL control: Turn the ignition key to ACC or ON, and then press the PWR button while the system is off to call up the mode (radio or CD) which was playing immediately before the system was turned off. To turn the system off, press the PWR button. Turn the VOL control knob to adjust the volume. This vehicle may be equipped with Speed Sensitive Volume (SSV) for audio. The audio volume changes as the driving speed changes. AUDIO button (BASS, TREBLE, BALANCE, FADE, SSV and BEEP): Press the AUDIO button to change the mode as follows: Bass → Treble → Balance → Fade → SPD VOL (SSV if so equipped) → Beep ON/OFF → Audio → Bass To adjust Bass, Treble, Balance and Fade, press the AUDIO button until the desired mode appears in the display. Press the TUNE/FF·REW/FOLDER button to adjust Bass and Treble to the desired level. You can also use the TUNE/FF·REW/FOLDER button to adjust Balance and Fade modes. Balance adjusts the sound between the right and left speakers and Fade adjusts the sound level between the front and rear speakers. To change the SSV mode to OFF, LOW, MID or HIGH, press the TUNE/FF·REW/FOLDER button up or down. To change the Beep to ON or OFF, press the TUNE/FF·REW/FOLDER button up or down. This will enable or disable the beep sound heard during menu selection. Once you have adjusted the sound quality to the desired level, press the AUDIO button repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. Clock operation Pressing the CLOCK button displays the clock with the radio on or off. Press the CLOCK button again to turn off the clock display. Clock set 1. Press and hold the CLOCK button until it beeps for more than 1.5 seconds to enter the clock set mode. 2. The time will start flashing. Press the or SEEK/TRACK/FILE button to adjust the hours. 3. Press button the or TUNE/FF·REW/FOLDER to adjust the minutes. 4. Press the CLOCK button again to exit the clock set mode. The display will return to the regular clock display after 10 seconds, or you may press the CLOCK button again to return to the regular clock display. DISP (display) button: The DISP (display) button will show text about FM stations, CD or MP3 and SAT (satellite, if so equipped) information in the audio display. FM display mode To change the text displayed while listening to an FM station that broadcasts with Radio Data System (RDS), press the DISP button. The DISP button will allow you to change RDS information as follows: Station call number → Program type → Station information → Station call number. ● Station call number displays the radio frequency number of the station. ● Program type displays the type or category of radio station. Heater, air conditioner, audio and phone systems 4-21