2008 Nissan Versa Owner's Manual - Page 194

2008 Nissan Versa Manual

Page 194 highlights

D (Drive), the Overdrive off mode will be automatically turned off. WARNING When the high fluid temperature protection mode or fail-safe operation occurs, vehicle speed may be gradually reduced. The reduced speed may be lower than other traffic, which could increase the chance of a collision. Be especially careful when driving. If necessary, pull to the side of the road at a safe place and allow the transmission to return to normal operation, or have it repaired if necessary. Accelerator downshift - in D position - For passing or hill climbing, depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. Fail-safe When the fail-safe operation occurs, the CVT will not be shifted into the selected driving position. WSD0164 Overdrive (O/D) OFF switch When the O/D OFF switch is pushed with the selector lever in the D (Drive) position, the light in the instrument panel illuminates. See "Overdrive off indicator light" in the "Instruments and controls" section of this manual. Use the Overdrive off mode when you need improved engine braking. To turn off the Overdrive off mode, push the O/D OFF switch again. The indicator light will turn off. Each time the engine is started, or when the selector lever is shifted to any position other than If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may come on to indicate the fail-safe mode is activated, see "Malfunction indicator light (MIL)" in the "Instrument and controls" section. This will occur even if all electrical circuits are functioning properly. In this case, turn the ignition switch to the OFF position and wait for 10 seconds. Then turn the switch back to the ON position. The vehicle should return to its normal operating condition. If it does not return to its normal operating condition, have a NISSAN dealer check the transmission and repair if necessary. MANUAL TRANSMISSION (if so equipped) WARNING ● Do not downshift abruptly on slippery roads. This may cause a loss of control. ● Do not over-rev the engine when shifting to a lower gear. This may cause a loss of control or engine damage. 5-20 Starting and driving

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304

Overdrive(O/D)OFFswitch
When the O/D OFF switch is pushed with the
selectorleverintheD(Drive)position,the
light in the instrument panel illuminates. See
“Overdriveoffindicatorlight”inthe“Instruments
andcontrols”sectionofthismanual.
Use the Overdrive off mode when you need im-
provedenginebraking.
ToturnofftheOverdriveoffmode,pushtheO/D
OFF switch again. The
indicator light will
turnoff.
Each time the engine is started, or when the
selectorleverisshiftedtoanypositionotherthan
D (Drive), the Overdrive off mode will be auto-
maticallyturnedoff.
Acceleratordownshift
—inDposition—
For passing or hill climbing, depress the accel-
eratorpedaltothefloor.Thisshiftsthetransmis-
sion down into a lower gear, depending on the
vehiclespeed.
Fail-safe
Whenthefail-safeoperationoccurs,theCVTwill
notbeshiftedintotheselecteddrivingposition.
If the vehicle is driven under extreme con-
ditions, such as excessive wheel spinning
andsubsequenthardbraking,thefail-safe
system may be activated. The MIL may
come on to indicate the fail-safe mode is
activated, see “Malfunction indicator light
(MIL)”inthe“Instrumentandcontrols”sec-
tion. This will occur even if all electrical
circuits are functioning properly. In this
case, turn the ignition switch to the OFF
positionandwaitfor10seconds.Thenturn
the switch back to the ON position. The
vehicle should return to its normal operat-
ing condition. If it does not return to its
normal operating condition, have a
NISSANdealercheckthetransmissionand
repairifnecessary.
WARNING
When the high fluid temperature protec-
tion mode or fail-safe operation occurs,
vehicle speed may be gradually reduced.
The reduced speed may be lower than
other traffic, which could increase the
chance of a collision. Be especially care-
ful when driving. If necessary, pull to the
sideoftheroadatasafeplaceandallow
the transmission to return to normal op-
eration,orhaveitrepairedifnecessary.
MANUALTRANSMISSION(ifso
equipped)
WARNING
Do not downshift abruptly on slippery
roads.Thismaycausealossofcontrol.
Do not over-rev the engine when shift-
ing to a lower gear. This may cause a
lossofcontrolorenginedamage.
WSD0164
5-20
Startinganddriving