2008 Nissan Versa Owner's Manual - Page 171
2008 Nissan Versa Manual
Page 171 highlights
The system announces the names of the phones already paired with the system and their priority level. The system then gives you the option to delete a specific phone, all phones or listen to the list again. Once you choose to delete a phone or all phones, the system asks you to confirm this action. NOTE: When you delete a phone, the associated phone book for that phone will also be deleted. "Select ringtone" F Use the Select Ringtone command to select the tone heard in the vehicle when an incoming call is received. The system announces the name of the active phone and asks you to choose from the following commands: ● "Ringtone" - The system plays a ringtone and asks if you would like to select that tone. If you say "No", the system plays the next ringtone available and continues to cycle through the ringtones until you select one or quit. ● "Silent" - The system asks you to confirm your wish to disable the ringtone. "Bluetooth off" G Use the Bluetooth Off command to turn off the Bluetooth Hands-Free Phone System. When the Bluetooth Hands-Free Phone System is off, you will not be able to make or receive calls using NISSAN Voice Recognition. Also, you will not have access to the Phone Book. You can still use the Memo Pad and access Setup. 1. Position the vehicle in a reasonably quiet outdoor location. 2. Sit in the driver's seat with the engine running, the parking brake on, and the transmission in P (Park) (AT and CVT models) or N (Neutral) (MT models). 3. Press and hold the than 5 seconds. button for more SPEAKER ADAPTATION (SA) MODE Speaker Adaptation allows up to two out-ofdialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice that is stored in the system. The system is capable of storing a different speaker adaptation model for memory A and memory B. If memory A is available, the system will use memory A to store the model. If memory A is in use and memory B is available, the system will use memory B to store the model. If both of the memory locations are in use, the system will ask the user to select which memory location should be overwritten. 4. The system announces: "Press the PHONE/SEND ( ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END ( ) button to select a different language." 5. Press the button. For information on selecting a different language, see "Choosing a language" earlier in this section. 6. Voice memory A or memory B is selected automatically. If both memory locations are already in use, the system will prompt you to overwrite one. Follow the instructions provided by the system. 7. When preparation is complete and you are ready to begin, the press the button. 8. The SA mode will be explained. Follow the instructions provided by the system. Training procedure The procedure for training a voice is as follows. Heater, air conditioner, audio and phone systems 4-41